After writing the Sensors post. I got to thinking about that project and thought, if I got another set of...
So far, I’ve been following the instructions from https://diyodemag.com/projects/all_sky_camera_with_raspberry_pi I will be installing a BME280 – temperature, humidity and pressure,...
The concept of this quite simple. Take a Camera, point it up to the sky with a wide angle lens,...
I hit several limits with the original mainboard on my printer. Firstly the firmware was busting the limits of the...
After running my printer for a while, I found there was an inconsistency in the Z height. As the printer...
After making a few test prints, I realised that the filament wasn’t being delivered properly from the plastic extruder on...
One of the first upgrades that I did to my Ender 3 pro was to add a BL Touch bed...
During the 2020 lockdown, I started getting into the mindset of making things. I’d been facinated by 3D Printing and...
Whilst my Media center was running on a PI 3B, I had the occasional under voltage issue. This I noticed...
Something that I thought would be a fun edition to my media center would be to add an install of...
After writing the Sensors post. I got to thinking about that project and thought, if I got another set of
So far, I've been following the instructions from https://diyodemag.com/projects/all_sky_camera_with_raspberry_pi I will be installing a BME280 - temperature, humidity and pressure,
Recent Comments