Bonus project
After writing the Sensors post. I got to thinking about that project and thought, if I got another set of...
Sensors
So far, I’ve been following the instructions from https://diyodemag.com/projects/all_sky_camera_with_raspberry_pi I will be installing a BME280 – temperature, humidity and pressure,...
Initial construction, getting the camera setup working.
Whilst you would think this is the hard part. This really could not be much easier. Firstly, I started by...
Solar Powered All Sky Camera
The concept of this quite simple. Take a Camera, point it up to the sky with a wide angle lens,...
The TFT35 touch screen
As part of the mainboard upgrade, I also got an upgraded screen. I’m intending on running this in Marlin mode...
New mainboard
I hit several limits with the original mainboard on my printer. Firstly the firmware was busting the limits of the...
Dual Z lead screws
After running my printer for a while, I found there was an inconsistency in the Z height. As the printer...
Dual geared extruder
After making a few test prints, I realised that the filament wasn’t being delivered properly from the plastic extruder on...
BL Touch for bed levelling
One of the first upgrades that I did to my Ender 3 pro was to add a BL Touch bed...
3D Printer
During the 2020 lockdown, I started getting into the mindset of making things. I’d been facinated by 3D Printing and...
Recent Comments